Jump to content

B1 SE Plus Stringing

Recommended Posts

  • 2 weeks later...
On 5/28/2022 at 3:00 PM, helakejr said:

Tried to print attached stringing test. Much stringing. I'm using the standard B1 machine profile that has retraction distance at 7 mm. Does anyone know how to correct this situation?


four_square_cons.stl 11.05 kB · 0 downloads

Whenever you get a new printer you need to run through a full calibration by following the steps here:


Stringing/retraction is covered.

Link to comment
Share on other sites

  • 2 weeks later...

I tried everything related to the Cura settings to no avail, no change to the issue.  I was however able to fix most of the stringing (90%) when I installed the dual Z kit on my B1 SE Plus!



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...