SKR mini V2 with Anycubic Predator and Klipper

[MStar]

Hello, I'm trying to setup the Anycubic predator with the SKR mini V2 and klipper. I have a few problems and questions:

How can I connect a third fan to the SKR mini?

The Anycubic Predator has sensors for the x-y-z homing that require 5v. Where is the best place to get 5v from the board? Can I connect the ground and signal pin to the x-y-z endstops and get 5v from another connection on the board?

I'm making the printer.cfg file myself now. If there already is a printer config file for the Anycubic predator with the SKR mini V2 that would be awesome!

 

Kind regards,

MStar

[BTT Tony]

Hi,

A third fan can be connected to the power port and the E0-STOP port can get 5V.
Sorry, we don't have the firmware for this printer, you need to modify the parameters yourself.