Jump to content

Alarm/shutdown when heating bed with new SKR MINI E3 V3.0


Steve Meiners

Recommended Posts

Printer: Ender-3 V2 with BLTouch

Motherboard: BTT SKR MINI E3 V3.0

Printer was working with SKR MINI E3 V2 until the board died. I replaced it with the V3, built Marlin firmware and now it wont heat bed past 52C. Hotend heats fine up to 205C

Using Repetier-Server, I send a print with a bed temp set to 60C but, once the bed temp hits 50C it takes about a minute to reach 52C. Soon after there is a set of rapid beeps followed by a sustained beep until I power hit. This gcode has printed successfully on the V2 board before the V2 died.

 

Configuration_adv.h Configuration.h

Link to comment
Share on other sites

  • 4 weeks later...
  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...