Jump to content

Is there any technical product page for SKR V1.4 Turbo ?


Recommended Posts

Is there any technical product page for SKR V1.4 Turbo ? I can't find any.

Any specific pin setting for 24V? 

How to set i.e. pin 0.16 HIGH with M42? P16?

Any smoothieware starter cinfig.txt with TMC2209?

 

 

 

Link to comment
Share on other sites

  • 5 months later...

I have an issue with M42  

It does not appear to work for me

Asking for advice
Switching a relay on or off via G-Gode on a:-
 Creality Ender 5 Plus 
 Marlin-2.1.2 
 Bigtree Tech Octopus V1.1 STM32F446ZET6 chip
 Compile as ABM Panel : Environment STM32F446ZE_btt(512K)   Architecture : stm32f4      Re: STM32F446ZET6 chip

DIRECT_PIN_CONTROL   in Config_adv.h
//  #define Z2_DIAG_PIN                         PG11  // Z2-STOP  in pins_BTT_OCTOPUS_V1_common.h Commented out so that it doesn't conflict with M42 P11 S1 call

OctoPrint Terminal commands tried:-

M42 P11 S1
  
M42 M1 P11 S1

Relay used
5V Relay Module 2 Channel Arduino Raspberry Pi ESP8266 ESP32 Optocoupler ( only one channel used)
5 Volts from Bigtree Tech Octopus V1.1
Signal pin used P11 pin on Bigtree Tech Octopus V1.1

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...