SKR mini e3 v3 board and TFT35-e3 v3.0.1 screen.

[Bob Henderson]

 I purchased a SKR mini e3 v3 board and TFT35-e3 v3.0.1 screen. The board will not work in touch screen mode . The screen says no printer attached. I am running it on an ender3 v2. I have tried changing baud rate trough the TFT screen to match the board but nothing. How is it that BTT sells two items that are supposed to go together but won't talk to each other? I can't even seem to flash the board to try something other than the bug-fix version of Marlin.

[Bob Henderson]

FIXED sort  of but all good. A 4+1 Dupont connecter was perhaps not the best route for them to go. At least when the +1 is so loose. In addition the reset wire needs to be marked back to the TFT connector.

Edited January 29, 2023 by Bob Henderson