Jump to content

BIGTREE TECH smart filament sensor not working


AWESOMEka001

Recommended Posts

Hello.

I am using an SKR 2 and a tft35v3 and just bought a smart filament sensor, I have followed the instruction manual and have wired it up to e0fildet on my main board. I compiled the firmware and it is not detecting. When I send m119 it says open but when I move the filament ~7mm through it goes to TRIGGERED and then back once I move it more. Does anyone know why this is happening? Thanks.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...