Jump to content

dVW

Dave

By Dave
in Other Accessories

 Share

Recommended Posts

Dave

Dave

Posted
Posted

Hi I have a ender 3  and replaced the board yesterday with  a SKR mini E3 V3 and a tft 35 V3.  the problem is  the display shows the ambient temperature as 85 and will not heat up until I set bed temp above this. the wiring is correct the thermistors are in the correct plugs, the resistance reads 101K the solder joints are fine, when I unplug the thermistor the display still shows 85 degrees ambient

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...