Broken USB port on SKR mini E3 v3.0

[MaximC]

So, i'll start this thread by saying this: I am at fault here. 

I purchased an SKR mini board to replace the stock one on my ender 3, everything worked fine and is still working fine. 

The problem that I have is that my Micro USB post bacame unnattached I tried moving the printer with a cable there, so the connection was broken, I don't have microsoldering equipament to attached it again. 

My question is: 

Is there anyway I connect a usb cable to the motherboard? Thru dupont wires or something, or the only way to get it fixes is to microsolder the post back to the motherboard? 

Thank you all for your attention!

[BIQU info]

Hello, please contact our technicians to describe more details, and they will settle your problem as soon as possible. Here is the procedure and link:

https://biqu3d.com/pages/submit-a-ticket

Step 1: Verify your email address by checking the verification code in your inbox. (To ensure that our technical support can contact you correctly.)
Step 2: Filled in some details, such as your order number and the problem descriptions, even screenshots.
Step 3: Submit your ticket.

Then, our technical support will check your ticket and give some solutions within 24 hours on workdays. And please look for your junk mail for a while, sometimes our replies are wrongly recognized. 

Warm regards,
BIQU