BTT SKR Minu E3 V2 connection to CR10-S4 display

[GPPrint2022]

I purchased the SKR Mini E3 V2 as replacement for my CR10-S4 stock board. Is there a way to connect/use the stock LCD display with this board?
I noticed the original board has 2 LCD cables connected to EXP1 & EXP2, were the SKR mini only have one connector EXP1.

[BIQU info]

Hello, you could connect to the EXP 3 to use the LCD display. If you have any using problems, please feel free to contact our technicians by submitting a ticket. They will contact you within 24 hours on workdays. Here is the procedure and link:

https://biqu3d.com/pages/submit-a-ticket

Step 1: Verify your email address by checking the verification code in your inbox. (To ensure that our technical support can contact you correctly.)
Step 2: Filled in some details, such as your order number and the problem descriptions, even screenshots.
Step 3: Submit your ticket.

Then, our technical support will check your ticket and give some solutions within 24 hours on workdays. And please look for your junk mail for a while, sometimes our replies are wrongly recognized. 

Warm regards,
BIQU

[GPPrint2022]

7 hours ago, BIQU info said:

Hello, you could connect to the EXP 3 to use the LCD display. If you have any using problems, please feel free to contact our technicians by submitting a ticket. They will contact you within 24 hours on workdays. Here is the procedure and link:

https://biqu3d.com/pages/submit-a-ticket

Step 1: Verify your email address by checking the verification code in your inbox. (To ensure that our technical support can contact you correctly.)
Step 2: Filled in some details, such as your order number and the problem descriptions, even screenshots.
Step 3: Submit your ticket.

Then, our technical support will check your ticket and give some solutions within 24 hours on workdays. And please look for your junk mail for a while, sometimes our replies are wrongly recognized. 

Warm regards,
BIQU

Thanks for your reply. Not sure what EXP3 you refer to I could not find such connector in the diagram for my board.
 

[BIQU info]

Hello, please connect the EXP1 of SKR mini e3 v2.0 to the EXP3 interface of CR10-S4 display, then you could use the display.

 

[GPPrint2022]

thanks for the clarification!