Jump to content

Octopus v1.1 will not connect


todd

Recommended Posts

after about 20hrs. of on and off printing, powered my printer back up, and the display was blank and no backlight. looked into further and could not connect to Octo board over usb from Pi/Klipper. have changed and checked SD card, firmware, reloaded octopi, bootloader, unplugged everything from the board and am at a loss. any help would be appreciated

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...