Jump to content

SKR MINI E3 V3.0 Firmware Questions for CR-10S


Lizard
 Share

Recommended Posts

Hi,

Currently the BIGTREETECH github for the SKR Mini E3 V3.0 has firmware for Ender 3 and Ender 5 while the Marlin source code has example config files for the CR-10S for the SKR Mini E3 V2.0 but not 3.0. I have a completely stock CR-10S and just got the SKR Mini E3 V3.0. As someone with very little experience editing firmware configuration files, how easy would it be to edit the Marlin example config files for the SKR Mini V2.0 for the V3.0? I'm thinking I basically just need to edit the new motherboard specific stuff from the source code from BIGTREE for Ender3.0 into the existing CR-10S V2.0 example code to deal with the difference in processor and fan setup (and any other less obvious changes) between the V2.0 and V3.0. Then I can just leaving the printer stuff (bed size, filament run out, etc.) from the V2.0 config, right? Would this be the right way to approach this or am I way off the mark?

Thanks!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...