Jump to content

Stepper Driver on The SKR Mini E3 V3


Recommended Posts

I bought a new SKR Mini E3 V3 and installed it in my Ender 3 V1. I had a layer shift problem always in the X axis. After checking all mechanical possibilities I change the mother board. I had a spare new board for another project. Long story short the layer shifting went away. I suspect a bad X axis stepper driver. Is this possiable to replace stepper driver on this board? The web site says this is a "UART mode of on-board TMC2209" Stepper driver. Thanks in advance.

 

Carl

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...