Jump to content

SKR 3 EZ won't connect to Pi5 via UART using Klipper

PythonesqueSpam
 Share

Recommended Posts

PythonesqueSpam

PythonesqueSpam

Posted
Posted

My BTT SKR 3 EZ has just arrived.  I want to use UART to connect to the GPIO of my Pi5 and made two cables.. one with crossover for TX and RX on PA9/PA10 and one without.  I flashed the firmware accordingly (processor= STM32H723, Comms=USART1 on PA10/PA9), changed config.txt (removed console=serial0,115200)  and command.txt (added dtoverlay=pi3-miniuart-bt) on the Pi5 and set serial: /dev/ttyAMA10 in printer.cfg of Mainsail, but can't connect to the MCU with either cable. Any ideas why it's failing?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...