Octopus pro v1.1 - software flashing problem

[symptom]

Hello, I have a problem with FLASHING firmware on the motherboard - Octopus pro F429.
 

• SD card is using FAT32 formating
• firmware is correctly named (downloaded from BIGTREETECH git)
• status led is not "blinking" when sd card is inserted
• STM32CubeProgrammer works fine - I am able to connect to motherboard and download bootloader from BTT Git
• I tried flash motherboard via Raspberry pi with following error:
  
   dfu-util: Could not read name, sscanf returned 0
   Failed to flash to 0483:df11: Error running dfu-util

Thanks for any advice.

 

 

 

 

 

[kaktus]

Hello.

I am also a newbie.
I have a different controller board however I can say that in my case it helped to use a 1GB card.

To perform programming from the RPi, you need to identify the communication port. In my case it looks like this:

$ ls /dev/serial/by-id/*
/dev/serial/by-id/usb-1a86_USB_Serial-if00-port0  /dev/serial/by-id/usb-Klipper_stm32h723xx_140016001551303531313638-if00

 

Read the section "Building and flashing a microcontroller".