Jump to content

microprobe on skr 1.4 turbo


Marty Z

Recommended Posts

I just ordered a microprobe to replace my bltouch on an ender 5 plus with an SKR V1.4 Turbo board. Reading thru the manual, which as usual if very uninformative, I can't find instructions for my board.

My bltouch now is connect to the servo 3 pin and 2 pins on the z end stop, pin 1.27. Do I plug the microprobe in the same way or do I plug the 2 pin into the probe, pin 0.10? And what do I change in Marlin, if anything, from the bltouch setup?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...