Your esteps value for h2 v2

[Denny2k]

Since i got my h2 v2 i had some issues to complet prints.

The filament stucks at 8 of 10 Prints. After i tested a lot of settings in cure, i reduced(!) the esteps Value by 10% ( now 844, luckily no underextrusion). Since i reduced i dont have any Problems to finish my Prints, aswell on 50mm/s (tpu).

Anyone did have the same problems, what did you change?

[BIQU info]

On 7/3/2022 at 5:00 PM, Denny2k said:

Since i got my h2 v2 i had some issues to complet prints.

The filament stucks at 8 of 10 Prints. After i tested a lot of settings in cure, i reduced(!) the esteps Value by 10% ( now 844, luckily no underextrusion). Since i reduced i dont have any Problems to finish my Prints, aswell on 50mm/s (tpu).

Anyone did have the same problems, what did you change?

If you have any product issues, please submit a request and we will arrange for an engineer to communicate with you as soon as possible.

Click on the top navigation "Submit a request" or Please click
https://support.biqu3d.com/hc/en-us/requests/new