BIQU B1 with SKR3 EZ and Marlin 2.1.x

[ElBernado]

Hi.

I've installed a SKR3 EZ board with EZ2209 drivers to my standard BIQU B1 printer (no BL Touch, only 1 Z-axis). I am trying to run the machine using a standard Marlin 2.1.x.

I took over the parameters for config.h from the standard BIQU B1 repository for Marlin 2.0.x

Right now I am struggling with the axis homing. When I push the 'home' button the motors drive approx. 15mm in '+' direction and then stops. Same behaviour for x, y and z axis. 

[ElBernado]

Solved: ..._ENDSTOP_HIT_STATE must be LOW instead of HIGH.