Jump to content

octopus v1.1 and tmc5160T pro spi communication not working

Max N.

By Max N.
in BIGTREETECH Motherboards

 Share

Recommended Posts

Max N.

Max N.

Posted
Posted

I have a octopus v1.1 board instaled in my 3d printer and want to upgrade the x/y stepper drivers from tmc2209 to tmc5160T pro. I think i have setup the config for the drivers correctly.

 

[tmc5160 stepper_x]
cs_pin: PC4
spi_software_sclk_pin: PA5
spi_software_mosi_pin: PA7
spi_software_miso_pin: PA6
run_current: 1.6
interpolate: False
stealthchop_threshold: 0

[tmc5160 stepper_y]
cs_pin: PD11
spi_software_sclk_pin: PA5
spi_software_mosi_pin: PA7
spi_software_miso_pin: PA6
run_current: 1.6
interpolate: False
stealthchop_threshold: 0

 

My Z drivers are also tmc2209, when I run a G28 command to home all axes, the bed moves. But when the x and y axes are supposed to move, the printer gives this error: "unable to write tmc spi 'stepper_x' register globalscaler". Is the Octopus v1.1 card not working with the tmc5160T pro drivers or is it my fault?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...