SKR 2 Not Staying On

[tinyface0]

What I did: flashed the firmware as soon as I got it (was working fine with usb mode at the time) switched over the jumper to psu mode got it wired up (followed a Chris's Basement video more or less) and powered it up.

What it's doing: when it powers up the screen will turn on, the bltouch with do a probe test then it'll turn off. When i try the usb mode now, it won't even turn on (checked with a laptop, and a phone charging block)

This a defective board or am I doing something wrong?

[BIQU info]

5 hours ago, tinyface0 said:

What I did: flashed the firmware as soon as I got it (was working fine with usb mode at the time) switched over the jumper to psu mode got it wired up (followed a Chris's Basement video more or less) and powered it up.

What it's doing: when it powers up the screen will turn on, the bltouch with do a probe test then it'll turn off. When i try the usb mode now, it won't even turn on (checked with a laptop, and a phone charging block)

This a defective board or am I doing something wrong?

If you have any product issues, please submit a request and we will arrange for an engineer to communicate with you as soon as possible.

Click on the top navigation "Submit a request" or Please click
https://support.biqu3d.com/hc/en-us/requests/new

[tinyface0]

This is solved, my filament run out sensor was connected wrong