BTT EBB sb2209 RP2040 and Klicky Probe

[Emmanuele]

Hi can you please help me configuring Klicky probe on this board?

I tried using the probe port and (GND and !EBBCan:gpio21) but it doesn't result open once the probe is attached nor change state when clicked.

Is it possible to have the schematics of this board?

Thanks in advance 

[Coco-BQ Team]

Hello, if you have any using problems, please "submit a ticket" on the Community page, and choose it from the navigation.

Our professional technicians will settle down your confusion as soon as possible.

Here is the link：https://biqu3d.com/pages/submit-a-ticket

Have a nice day!

[Stefan]

Hi!

 

Did you get help?

I have the same Problem and can't fix it.

 

Thanks

[Andreas]

I had exactly the same problem and finally found the solution on the Voron Discord.  Apparently it's not possible to use gpio21 as it connects to some other component before the mcu.  Use gpio22 with a pullup symbol instead.  Like this in your Klippy config:  ^EBBCan:gpio22

Cheers

[David Ribbe]

If I understand the question correctly, I used the PD5 pin (and ground) on my sb2240 in the probe (aka Klicky) section of my printer.cfg   (may also work in a sub .cfg file.

 

[probe]

pin: EBBCan: PB5     # CAN Klicky Pin 

Edited October 21, 2023 by David Ribbe