Microprobe does only accurate Z probe

[David Vodak]

Hi all, just got new microprobe v2.0, so i made changes to Marlin firmware as described in manual. But what i get is that the probe deploys, but instead of 1st part fast bed touch and then 2nd accurate touch it only makes 2nd part accurate measurement and after few mm's printer is halted, as it expects bed just to be few mm's far. Tried to change almost every part of bed leveling in Marlin configuration. Did someone have same problem? Any help is appreciated. David

[Coco-BQ Team]

Hello, if you have any using problems, please "submit a ticket" on the Community page, and choose it from the navigation.

Our professional technicians will settle down your confusion as soon as possible.

Here is the link：https://biqu3d.com/pages/submit-a-ticket

Have a nice day!