Jump to content

SKR Mini E3 v3.0 prints first few layers, then quits


Recommended Posts

I have installed an SKR Mini E3 V3.0 with a BLTouch in my Ender 3.  It took a while to get the BLTouch working, but it seems to be working as expected now.  
The problem I am now experiencing is when I print something, the BLTouch does it's calibration run and the print starts...  I get the percentage of completion on the display, but after the first few (maybe 5 - 10) layers, the completion jumps to 100% and the print stops.  I have tested with and without the TFT35 E3 V3.0.1 connected, and I get the same results.  I have tried with several  gcode files, and they all end the same.  I cannot get anything to print past the first few layers.
Any help you can offer would be appreciated. 
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...