Jump to content

BIQU H2 Smart Extruder & Klipper

Recommended Posts

Hello I have the H2 Smart version and I'm little bit lost with the fact that the sensor part of it comes with two connectors, one for blockage and one for runout. Now there is almost no material on the product available and I have been looking the "Smart filament sensor" materials to go forward, but that comes with only 1 connector (3 cables). 

I repurposed the (Creality 4.2.2) Z stop pin for the other connector and used for the other I utilized the free 3 pin connector between X-endstop and extruder thermistor. 

How should I configure Klipper to utilize these? 

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...