Problems with SKR PICO compiling

[Tonez93]

hello guys i have a problem , i'm setting up a skr pico on a custom printer based on cr10 , i made almost all working , but i have this problem with the heater ..i have set this . i have the problem that the heater is always up as seen in photo on the led . even if set on 0% , so i have to manually wire it off for not overheating.

[extruder]

step_pin: gpio14

dir_pin: !gpio13

enable_pin: !gpio15

microsteps: 16

rotation_distance: 33.500

nozzle_diameter: 0.4

filament_diameter: 1.75

heater_pin: gpio23

sensor_type: EPCOS 100K B57560G104F

sensor_pin: gpio27

control: pid

pid_Kp: 22.2

pid_Ki: 1.08

pid_Kd: 114

min_temp: 0

max_temp: 250max_extrude_cross_section:2

[BTT Tony]

Hi ，
Thanks for your information.

Please send me the video on this case" the heater is always up as seen in photo on the led . even if set on 0% , so i have to manually wire it off for not overheating."

I will check it 

[Tonez93]

i replied in private with a video . Thanks

[Tonez93]

Here is the problem i talked about.

[BTT Tony]

Hi,

Thanks for your video.

Does this phenomenon happen to the HB port?

Edited May 13, 2022 by BTT Tony

[Tonez93]

Hallo , no , it happen to the HE port.

[BIQU info]

On 5/13/2022 at 5:36 PM, Tonez93 said:

Hallo , no , it happen to the HE port.

If you have any product issues, please submit a request and we will arrange for an engineer to communicate with you as soon as possible.

Click on the top navigation "Submit a request" or Please click
https://support.biqu3d.com/hc/en-us/requests/new

[ACD576]

Hello, is there any solution?

I had the same problem with the heatbed