Hayashi Posted April 20, 2022 Share Posted April 20, 2022 So after waking up to my printer screeching from what was most likely a power surge both my PSU and board were most likely fried so I replaced them (Probably thermal throttle from the screeching). I got a SKR Mini E3 V2 and replacement power supply. I installed them and noticed my bed heat was increasing on it's own so I disconnected it for the time to see if I could print, printer was working normally for a few minutes then I hear a grinding noise from what I assume is one of the motors. Print stops and my LCD goes blank. I have no clue what is doing this. Firmware, hardware? I have no clue what's causing all these problems from a perfectly functioning printer the night before. Quote Link to comment Share on other sites More sharing options...
BTT Tony Posted April 21, 2022 Share Posted April 21, 2022 Hi , Thanks for your information. Please update the firmware Quote Link to comment Share on other sites More sharing options...
Hayashi Posted April 21, 2022 Author Share Posted April 21, 2022 42 minutes ago, BTT Tony said: Hi , Thanks for your information. Please update the firmware I did this and still nothing. Quote Link to comment Share on other sites More sharing options...
BTT Tony Posted April 23, 2022 Share Posted April 23, 2022 Hi , Thanks for your information. Does the firmware update successfully? Does it turn to CUR file? And please send me your video to reflect your printer issue. I need to check it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.