Jump to content

prints start off the bed


Recommended Posts

Hello, I am currently using cura slicer. Every time I try to print anything other than the preloaded prints that came with the printer it wants to start printing off the edge of the printer bed. I went into my slicer settings to make sure the printer settings were right and that is all ok. I don't know what is going on.

Link to comment
Share on other sites


1. Please add this item to increase the adhesion at the bottom, which can be leveled to make the nozzle closer to the hot bed
2. Pay attention to your layer thickness and the bottom layer thickness settings, please check the following pictures



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...