SKR 1.4 E1 Max Temperature

[Leandro Oliveira]

My board arrived about 8 days ago.
I configured Marlin and it was running great.
But now when starting the SKR 1.4 board, the error message appears:
E1: MAX TEMPERATURE please Restart.

Can someone help me?

 

[koehlr]

Did you checked your wiring of the thermistor? Is everything okay?
Maybe you can replace your thermistor with a spare one to check if your current thermistor is broken.
You can also try to reflash your Marlin and see if it works.

[Leandro Oliveira]

 

I already reflashed Marlin.
I've already replaced the thermos.

It didn't help.

[koehlr]

I've read that sometimes this error can occur if the screw on the thermistor is too tight. So gradually loosen the screw, restart the printer and retry until it (hopefully) works was an solution.

If this also not works I think you should contact the tech support for help, the support of the store where you purchased the board to get a replacement or just buy a new board.