Jim Cerul Posted February 24, 2022 Share Posted February 24, 2022 Is there any instruction on how to get the homing to function while using the CR-Touch unit? Using either of the firmware for the BL-Touch, the X and Y home properly, then the Z does nothing or runs up rather than moving down to the contacting position. Quote Link to comment Share on other sites More sharing options...
Leonard Posted February 27, 2022 Share Posted February 27, 2022 [bltouch] sensor_pin: ^PC14 control_pin: PA1 x_offset: -45.1 y_offset: -3.2 #z_offset: 1.5 speed: 5.0 stow_on_each_sample: true probe_with_touch_mode:true Quote Link to comment Share on other sites More sharing options...
Leonard Posted February 27, 2022 Share Posted February 27, 2022 hey its the pin mappin issue sensor pin needs the ^at the beginning of pc14 Quote Link to comment Share on other sites More sharing options...
Leonard Posted February 27, 2022 Share Posted February 27, 2022 this is for the klipper firmware Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.