How to conect correctly runout sensor in my Ender 3 pro V2 with BTT SKR Mini E3 V2.0 and Bigtreetech tft 35 E3 V3.0

[franco_hurtado_1]

How to conect correctly runout sensor in my Ender 3 pro V2 with BTT SKR Mini E3 V2.0 and Bigtreetech tft 35 E3 V3.0.
In marlin mode it works correctly, but in touch mode when trying to print a dialog box appears that says "Filament exhausted". My firmware version of marlin its 2.1.1 bugfix, and the firmware of Bigtreetech its v27x

[BIQU info]

Hello, if you have any use problems, please feel free to contact our technicians by submitting a ticket. They will contact you within 24 hours on workdays. Here is the procedure and link:
https://biqu3d.com/pages/submit-a-ticket

Step 1: Submit a ticket from the link.
Step 2: Receive the verification code in your inbox. (To ensure that our technical support can contact you correctly.)
Step 3: Filled in some details on the ticket page, such as your order number and the problem descriptions, even screenshots.
Step 4: Submit your ticket.

Then, our technical support will check your ticket and give some solutions within 24 hours on workdays. And please look for your junk mail for a while, sometimes our replies are wrongly recognized. If you still can't get the verification email or response email, please contact us again, thanks for your patience.

Warm regards,
BIQU