Jump to content

found outdated data

John

By John
in Other Accessories

 Share

Recommended Posts

John

John

Posted
Posted

I have installed the mini SKR E3 V3 and lcd combo in my Ender 3. Initially when I hooked up the LCD I didn't install the TFT ribbon. the LCD seemed to work fine, touch screen or knob. However, it said no printer attached. Once I realized I hadn't hooked up the TFT ribbon and corrected this, the touch and knob no longer functioned. Attempted to reload the firmware and TFT files. Now I get the notification, "Found Outdated Data". Asks you to load the SD card and use the reset button. No matter what I do it stays the same now. Have tried many times to reload the Firmware and TFT files from the downloads. Does anyone have any suggestions. Haven't received any response from tech support so far.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...