Jump to content

BTT Microprobe status always TRIGGERED when using Marlin firmware


Recommended Posts

I am currently having a problem with BTT Microprobe V2.0 when using Marlin firmware. The status of the probe when I run M119 is always TRIGGERED when it deployed or not. The motherboard I used is BTT Octopus V1.1.

I already checked both the probe and the connecting wire and there is no problem with them. When I tried a BLtouch on the motherboard, the status report works normally. So there should be no problem with the hardware.

The firmware I used is Marlin 2.1.2.2. I attached the configuration files and the pin file below.

Configuration.h Configuration_adv.h pins_BTT_OCTOPUS_V1_common.h

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...