Jump to content

Ender 3V1 build using BIGTREETECH SKR MINI E3 V3.0 32 Bit

CBosson
 Share

Recommended Posts

CBosson

CBosson

Posted
Posted

I installed a SKR mini E3 mother board in my Ender 3. After flashing the firmware, see below, and running a few test prints, I got a nozzle clog. Then I noticed the hot end cooling fan. It will turn on when the hot end is heating but the moment the heat is off the fan stops. I think this fan should continue to run until the hot end is cool again. Dose anyone have any insight on how to fix this? Thanks in advance.

firmware-ender3 (3).bin

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...