Manta M8P V2 can connection

[Kim Jensen]

I have a Manta M8P V2 the canbus it is marked TX and RX on the Can connection, on all other BIQU boards it is marked H and L. I'm trying to connect it to a EBB36.

Does the TX on the Manta goes to L or H on the EBB36?

Thanks.

[Bryan Johnson]

According to https://github.com/bigtreetech/Manta-M8P/issues/98

TX = CAN Low

RX = CAN High

Edited December 25, 2023 by Bryan Johnson

[kaktus]

I am happy to welcome another user of the Manta M8P v2.

I am glad that I am not the only owner of this powerful controller.

 

Kim and Bryan, are you already printing with the M8P v2? Or are you still learning about the possibilities and fine-tuning the configuration

[Heinrich Freislich]

Hi

Does anyone know if you need the U2C board when you connect the M8P to the EBB36 board? Can it connect directly from the main board? 

Equipment = M8P + CB1 + EBB36

[Hexus]

 

[Ingo J.]

On 1/24/2024 at 9:55 AM, Heinrich Freislich said:

Hi

Does anyone know if you need the U2C board when you connect the M8P to the EBB36 board? Can it connect directly from the main board? 

Equipment = M8P + CB1 + EBB36

Hello. I have the U2C and EBB42 or other Canbus Adapter. But it dont work nice. Klipper found one, two or no canbus. The U2C was often read - but not the Adapter to put on the U2C.

#+