Jump to content

SKR Mini e3v3.0, TFT35 v3.0


Harty

Recommended Posts

I am having troubles getting my lcd to communicate with my display, the display says "no printer attached" yet i have everything plugged in correctly. Also i have 2 Red Leds on the upper left side of my Skr board(, and one Red led on my tft35 board labeld - (O2) Image

Link to comment
Share on other sites

Hi,

Please check

"1. Please make sure that serial port 2 is enabled in the marlin firmware, and the baud rate is set to 115200


2. Please confirm that the wiring between the motherboard and the touch screen corresponds to
   Motherboard Touch Screen
    5V<->5V
    GND<->GND
    TX<->RX
    RX<->TX
    RST<->RST

3. Make sure the baud rate of the touch screen is also 115200"

微信图片_20220302185104.png

  • Thanks 1
Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...