Searching for Videos on CR10 V3 UPGRADE to BTT SKR E3 V3.0

[Martin Gutierrez]

Hi Folks:

First time poster.  I have a CR10V3 whose original board zoinked on me. I love this printer.   I am replacing the board  with the BTT SKR E3 V3.0 board, TFT35-3 V3 and Klipper firmware  I am also awaiting delivery of the BLTouch Sensor Expansion Module Pin 27 Upgrade Adapter Sensor to avoid any wire cutting and a second BLT Touch for the 2.8 mm filament mutant plate  I'll add that the previous upgrade is the Bondtech DDX Extruder and Slice Engineering mosquito Hot End and the BLT Touch.  To further complicate things, I am adding the Wham Bam mutant to use a 2.85 mosquito hot end.  I was given at least 35 1 kg rolls of 2.85 mm PLA.  I see lots of video for other printers but not the CR10 V2/V3 unless I am not googling correctly.  Can you all help me address the following questions.

1. In photographs, showing the current installed wires, are they in the correct slots?

2. Where do the the wires go for the ones not connected?