Jump to content

SKR Mini E3 V3.0 suddenly can't reliably control the extruder

Joe Kyle

By Joe Kyle
in BIGTREETECH Motherboards

 Share

Recommended Posts

Joe Kyle

Joe Kyle

Posted
Posted

I upgraded my printer with the SKR Mini E3 V3.0 a few weeks ago, and it was working without an issue. Suddenly, it can't reliably control the extruder. Sometime it will extrude properly for a bit, but then reverse and retract despite not being called on to retract - this occurs during printing and when commanding the extruder manually. The extrude and retract seem to run at different rates, despite sending consistent G codes with the same distance to move, and again, sometimes reversing in mid-move.  Only the extruder seems to be affected, X, Y and Z moves seem fine.

Any ideas? Could this be a stepper driver issue specific to the extruder?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...