SKR MINI E3 V3.0 SPI1 CS? (on Klipper)

[Igor Fulvi]

I would like to use the ADXL 345 by connecting it to the SPI1 port, using the Klipper firmware.
Searching the web, I found a configuration that seems to work:

[adxl345]
axes_map: x,-y,z
cs_pin: PC7
spi_bus: spi1

but rather than using the PC7 pin for the CS I would like to use the appropriate NSS pin, which is on the SPI1 connector, but I don't know how to address it. Is it enough to use spi_bus: spi1 without specifying the cs_pin?

Edited November 18, 2022 by Igor Fulvi

[BIQU info]

Hello, if you have any using problems. Please feel free to contact our technicians by submitting a ticket. They will settle down your problem soon. Here is the link:

https://biqu3d.com/pages/submit-a-ticket

 

[Fernando C L silva]

Olá estou precisando de ajuda com o cabo flat da placa Acelerômetro ADXL 345 alguém tem para passar esta informação .

Grato