Jump to content

Hermit Crab to BIQU SKR SE-BX V2.0 wiring

Recommended Posts


Does anyone have experience on wiring the standard (not CAN version) of the Hermit Crab to the SKR SE-BX V2.0 control board (BIQU BX).

If I look at the wiring for the stepper motor to the E0M connector the pins are mismatched : 2B on the control board connect to 2A on the Hermit board, 1B to 1A.... Should I rewire the connectors ?

Also wich is the driver fan or the nozzle fan : fan 1, fan 0 ?

And finally does the induction proximity sensor connect to the BL touch connector or is it different ?

The cable harness also has a few unlabelled wires, what are they supposed to used for ?

I fear to blowup the controller board and so I would greatly appreciate any help.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...