Jump to content

U2C board will not enter DFU mode, It looks like its Bricked

Del

By Del
in Other Accessories

 Share

Recommended Posts

Del

Del

Posted
Posted

Hello, I do not know where to start with this issue.  Trying to setup my Klipper installation to run Canbus to the Print head etc.  I can program the head board without issues but when I try to enter DFU mode on the Btt U2C board I cannot get it to go into the mode.  The Green and Blue LED are always on and I cannot turn them off,  Aslo the STM32 Cube Programmer will not see the device.  I have tried everything I can find on the web to enter the DFU mode to no avail.  Any Ideas on how to force this mode on a U2C module, Powering up whilst holding the Boot Button does nothing.  The LED do not change mode or anything different.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...