Jump to content

SKR Mini E3 V3.0 Endstops not registering with Klipper


Recommended Posts

Hi all, I just got a Mini E3 V3 and setting it up for the x and y steppers. I'm trying to get the endstops to register with Klipper. No matter how I set the pins in the config they always say triggered. I've tried with ^PC0 and 1 for pullups and not. The only way they change is with the ^!PC0 but still won't change with the switch. The sensorless jumpers are not installed on the pins. Is there something with the mini I'm not seeing? I'm using the query_endstops command. The board is connected and comunicating with the ras pi4.

Link to comment
Share on other sites

Well after playing all day and finally asking for help, I found my stupidity.  The one wire I used had two layers of insulation and was so small I didn't notice it when putting on the pins for the control board. Duh! Thanks anyway

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...