SKR 3 burned due to reverved drivers

[Kaan Kasım]

I did the mistake I thought I'd never do and burned the board in the process. Now I can't connect to it anymore and I doubt it but is there a way to save this board? I don't know if MCU got burned too. I was using Klipper at the time so the reverse insertion protection didn't work I believe.

[koehlr]

Do you only burned the drivers or the board?
If only the drivers is damaged, then you can change them, I guess.
But when you can see physical damage to the board then the board is probably  done and you need a new one.

[Kaan Kasım]

That's what I figured. No visible damage but smoke came out from the driver socket and I can't connect via usb without any drivers attached.